#Supermicro raid monitor software software#

To Stop a Secure Erase in Progress With the ACUġ.To Perform a Secure Erase on Disk Drives With the ACU.This section contains the following subsections: You can use the ACU, a tool of the BIOS RAID Configuration utility, to create and manage arrays. Using the ACU to Create and Manage Arrays

Confirm that Disk Utility reports the correct configuration of attached target devices.

Complete a bus scan by using the Rescan Drives option in the ACU.į. Replace/reinsert the hard disk (new or same) into the enclosure slot (same or another unused slot).Į. Confirm that the Disk Utility reports the correct configuration of attached target devicesĭ. Complete a bus scan by using the Rescan Drives option in the ACU.Ĭ. If a hard disk drive is to be removed and replaced either into the same slot or a different unused slot using the same disk drive or a new disk drive, you must perform a bus scan between the removal and the replacement steps, as follows:ī.Hot unplug and plug, replace/reinsert, of HDDs is supported under the following conditions: Hot-Unplug and Plug Replacement/Reinsertion Conditions After the hard disk drive is added to the enclosure, you must perform a bus scan by using the Rescan Drives option from the main menu of the ACU.Hot-plug, add, of HDDs is supported under the following conditions: You must confirm that the Disk Utility reports the correct configuration of the attached target devices.After the hard disk drive is removed from the enclosure, you must perform a bus scan by using the Rescan Drives option from the main menu of the Array Configuration Utility (ACU).The hard disk drive to be removed must not be a part of a logical device (its status must be ‘available’).Hot-unplug, removal, of HDDs is supported under the following conditions: Note - Hot-plugging of hard disk drives is NOT supported during periods when the controller is busy performing actions on logical drives (building, rebuilding, or migrating RAID volumes). Hot-Unplug and Plug Replacement/Reinsertion Conditions.However, hot-plugging of SAS/SATA hard disk drives (HDDs) is supported, but only within hard disk enclosures and under the following conditions: Hot-plugging of hard disk enclosures is not supported from within the BIOS RAID Configuration utility. Understanding Hot-Plug Limitations and Conditions Within the BIOS RAID Configuration Utility Using the Disk Utilities to Manage Disk Drives.Using the -Select Utility to Modify HBA Settings.Using the ACU to Create and Manage Arrays.Running the BIOS RAID Configuration Utility.Understanding Hot-Plug Limitations and Conditions Within the BIOS RAID Configuration Utility.Introduction to the BIOS RAID Configuration Utility.This appendix contains the following sections: Instead, use the Sun StorageTek RAID Manager graphical user interface. Note - If you are not an advanced user familiar with working in a computer BIOS, do not use the BIOS RAID Configuration utility tools.

#Supermicro raid monitor software software#

For more information, see the Sun StorageTek RAID Manager Software User’s Guide at: Instead, use the Sun StorageTek RAID Manager graphical user interface (GUI).

Note - If you are using a SPARC system, you cannot use the BIOS RAID Configuration utility. The BIOS RAID Configuration utility is a BIOS-based utility that you can use to create and manage controllers, disk drives and other devices, and arrays. Using the BIOS RAID Configuration Utility Sun StorageTek SAS RAID HBA Installation Guide